Continued from post 2020-01-15 I dug through my drawers and boxes of transistors and found a bunch of MPSA56 PNP general purpose on tape, and put them into the LO and mixer. I think they helped slightly – they are lower minimum fT than the 2N3906s. I adjusted – optimized – the trimpots I had
(Read More…)
I’m thinking of pulling up the end of the 100 ohm and looping the lead a few times through the ferrite bead. If that still doesn’t stop the ringing, I’m thinking about replacing the bead with an RF choke. Every time the ringing is reduced the reception gets better. I checked to see if I
(Read More…)
This photo is a detector diode that was broken during replacing the electrolytic capacitors. The lead on the top was twisted, apparently putting stress on the glass package. I replaced it with a 1N270 germanium diode. comment from fb group Vintage Transistor Radios Did you notice that the leads are magnetic? They stick to the
(Read More…)
I posted this a few days ago.https://m.facebook.com/groups/606087512820068?view=permalink&id=2638214152940717 Now I’ve replaced the capacitors in another one very similar, a DE LUXE. It’s not quite as complete and in as good a shape as the Encore. What surprised me was that some of the electrolytic capacitors were bad (measured open) and the symptom was no sound whatsoever
(Read More…)
I spent too much time looking at the schematics and projects at this website. Lots of interesting things to download.https://www.qsl.net/va3iul/Homebrew_RF_Circuit_Design_Ideas/Homebrew_RF_Circuit_Design_Ideas.htm
From FB group Building Transistor Radios 2018-09-28 I see nothing wrong with using the ‘386 to directly drive the power output stage. It’s cheaper than a transformer. But I was thinking about how the current was flowing in the ‘386’s output transistors. Normally an electrolytic capacitor blocks any DC from flowing out of pin 5.
(Read More…)
I got the Vectronics VEC-131K aircraft band radio kit in the mail yesterday and warmed up the soldering iron to assemble it. It came at a decent price, so some of my complaints seem to be cost cutting measures. It comes with a decent assembly instruction manual, but some of the pages including the schematic
(Read More…)
from FB group Building Transistor Radios, 2018-09-07 Tom Miller Say a capacitor or inductor has a Q of 100. The losses are about 1/100 of the energy in the component. In a tuned circuit the capacitor Q is usually much higher than this – it has lower losses, so the more important is the Q
(Read More…)
From FB group Building Transistor Radios 2018-09-01 There are too many ‘gotchas.’ You have to put up a large sized antenna to gather enough power to run the circuit. That means you cannot use this in a city where the properties are too small, due to lack of space. You go to the country where
(Read More…)
From the FB group Building Transistor Radios Regenerative / reflex designs are not as stable as superheterodyne radios. One problem is the design depends on factors that are not predictable such as gain and feedback, which are not linear. The regenerative reflex depends on the circuit being on the verge of oscillation, which is not
(Read More…)
