From my comment on the FB group Bell Telephone Pat Chicas I worked for RSCCD, which owns the Sheriffs Training Center. Man, I would have loved to slap their hands! The OCSD installed their phone system on prem, and we supplied the data circuits, so our patch cords and theirs shared the same patch panels
(Read More…)
Suggestion for project on FB group Arduino Projects – Sept 17 Automated Gallows! A motorized winch adjusts noose. Asks for three officials to each press confirmation button. Has an emergency abort button. Counts down 5, 4, 3, 2, 1… Pulls the trapdoor latch! Monitors heartrate until no sign for 5 minutes Lights up sign “Execution
(Read More…)
I bought some surface mount 1N4148 diodes. They are so small I couldn’t find one when I dropped it on the bench! Here’s a photo of one setting on top of a regular transistor. It’s itty-bitty, teensy weensy! It’s not much larger than a fly speck! That’s it! That tiny black rectangle sitting on top
(Read More…)
After paying my water bill today, I left the Orange Civic Center and I glanced over to a front yard and thought I saw a funny looking black dog. On second glance, it was a pig! I was wondering if I was seeing things… 😱 😛 😸
From a FB group post. “primitive transistors” I think that’s ironic. The 555 makes the design easier for the builder. It has all the parts so the builder doesn’t have to build from scratch. Like making a cake using Betty Crocker’s cake mix instead of flour, eggs, etc, and no need for a recipe. It’s
(Read More…)
From my FB comment Some comments say measure with a meter, but fractional ohm resistors don’t measure, or barely measure with the typical ohmmeter. Instead, you should be giving better advice. You should use the device between your ears to find the resistance. The resistor should be put in series with another resistor of
(Read More…)
From YT reply to Neilgn 2017-08-20 Take any NPN transistor and measure the gain, and write it down. Then put a 1k resistor in series with the transistor’s emitter and connect the emitter to positive and base to negative of a power supply. Adjust the voltage until 2 or 3 volts are across the 1k
(Read More…)
I watched this YouTube video. I liked it, it’s a well made video. The author asks a question about the 9 min point. He was not sure why the voltage peaked out at about 40 volts, and then stayed the same. First, it is not wise to disconnect the LED load from the JT because
(Read More…)
