Fellow JT experimenter Quantsuff has been experimenting with a Joule Thief using the 2SK170 JFET, and it runs at 131 millivolts (0.131V), powered by a solar PV cell lit by a table lamp. This is a very good JFET for low voltages; I made a similar circuit a while back and it ran at several
(Read More…)
I built a Joule Thief using a 2N7000 MOSFET with the white LED across it, a standard coil (see below) and a voltage divider connected to the gate. I was trying to find out more about the MOSFET, such as the gate bias voltage needed to make it run on a 1.5V AA cell. The
(Read More…)
I blogged a schematic on May 15, but it took me until now to build the schematic. I tack soldered the PSO together with the components shown, except I did not use the two diodes and two 10k resistors. First off, according to this article, to get it to oscillate, the overall voltage gain of
(Read More…)
I ordered some IRLZ34 MOSFETs from Futurlec and they finally arrived, shipped from Hong Kong. I took one out of the bag and it was marked IRFZ34. What!?!? I ordered IRLZ34, not IRFZ34!! I took the rest out of the bag and I counted 33 of the IRFZ34, and 2 of IRF9Z34, which are not
(Read More…)
The Youtuber going by the name of Sanjev21 has read my comment about using the TN0702 low gate threshold MOSFET for a Joule Thief that will start and run below 0.6V. He replied that this has a Rds(on)of 4 ohms at 2 volts, which is “too high”. The problem is that he is using a
(Read More…)
I received the following comment from Mayank and this is the reply to his comment. Hi Watson, I have a 1V, 3A solar panel that I want to use to charge 6V SLA battery. I checked some other circuits on the web and they use big torriod cores with 2N3055 transistors. Can I use a
(Read More…)
