I got an email from QS showing how he put the buck DC-DC downconverter right at the point where it plugs into the proto board. This is really the way to go to eliminate any IR drops from the resistance of the leads. There are two items which I am concerned about, one being
(Read More…)
Andrew asked a question about a DC-DC converter: I need your advise on the following challenge I have an 8 volt 0.3amp solar panel which I would like to use to charge a small lead acid battery 12 volt no more than 10 AH. Could you suggest a simple JT circuit that could be used
(Read More…)
Well, it’s Friday the 13th. We just had a Friday the 13th just 13 weeks ago, and we will have another one in 13 weeks. Wow! That’s almost spooky! Friday really was Friday the 13th for me and my co-workers. We had several network problems, one which required me to run from one building to
(Read More…)
I made this and I used an old HP 721 power supply set at 31 volts to power the LEDs. The 8 LEDs on each side of the middle are in series and add up to about 25 volts. The two sides are then connected in parallel. The 721 PS is set for 30 mA
(Read More…)
This is a photo of an ancient Dressen Barnes power supply from the 1950s. It uses germanium transistors throughout. Some of them are located on the other side of the board, and the only thing that can be seen are the nuts holding them down and the two holes where the leads pass through. Some
(Read More…)
