A basic one transistor regen receiver uses an MPF102 JFET to give the regenerative gain. Also uses two transistors to amplify the audio to drive an earphone. How to Build an FM Radio Receiver
Posts Tagged ‘regen’:
2017-06-13 Another Regen Receiver Built – Success!
The previous regenerative receivers I’ve built have been 27 MHz, but they have not been successful, they haven’t received a decent verifiable signal other than the very strong one I made with a dip meter. So this time I would build a regenerative receiver that is much lower frequency, and I chose 10.000 MHz because
(Read More…)
2013-02-25 Regenerative Receiver Design
I received a Google Alert about this regenerative receiver schematic being posted to the RegenRX Yahoo Group (you may have to be logged on the view it). It’s quite complex for a regenerative receiver – the average regen set has just a few transistors. But its Achilles Heel is the front end. When I was
(Read More…)
