For each direction of travel, it consists of two solar cells connected in parallel opposing to a motor that’s geared down to turn the tracking so both solar cells are in the shade. https://www.facebook.com/reel/7341922389263306?mibextid=9drbnH&s=yWDuG2&fs=e
2024-04-20 RCWL-0516 Microwave Doppler Motion Sensor Module Schematic KO4BB
The modules use both the RCWL-9616 and the BISS-0001 but it seems the schematics are all labeled BISS-0001. The parts values are different. He gives some good information about them. They operate at 3.5 and 3.98 GHz – the ones I have were advertised at 5 GHz. Also he shows his own version that uses a
(Read More…)
2024-04-10 FM Regenerative Receiver Using MPF102 JFET
A basic one transistor regen receiver uses an MPF102 JFET to give the regenerative gain. Also uses two transistors to amplify the audio to drive an earphone. https://www.circuitbasics.com/what-are-fm-receivers/
2024-03-31 LoRa Modules From Reyax
Supposed to have 10 to 14 km range. But probably at very low data rates. https://www.facebook.com/reel/936216961243959?mibextid=9drbnH&s=yWDuG2&fs=e
2024-03-29 FM Crystal Set Uses Helical Resonator For Tuning
This is a long article but a very interesting project. It uses HSMS-2850 Schottky detector diodes in a discriminator. He uses WE 1200 ohm sound powered headphones. He’s Canadian. https://electronbunker.ca/eb/FMCrystalSet.html
2024-03-26 HVDC Module Teardown, Operation And Explanation
A 41 min. YouTube video shows operation, tears down, and explains the components. It seems that they are made with cheap chinesium components that are too low voltage ratings so they will fail prematurely if the HVDC is left on a long time or if the spark gap is too wide. Schematic from video is
(Read More…)
2024-03-22 USB Power Delivery Trigger Adapter
Some important information for those who wish to power their projects with a USB C “power delivery” adapter. You may need one of these. This is a YouTube short video.
2024-03-11 Flexible LED Filaments
Some information on what current and resistors to use. The LEDs are all in parallel and need about 3 Volts, current limited with a resistor. https://www.facebook.com/reel/909951727389682?mibextid=9drbnH&s=yWDuG2&fs=e




